Balboa BP100 Bundle with detached remote heater and the 4 button TP200T topside control panel. This compact basic control system is ideal to retrofit in smaller hot tubs with 1 or 2 pumps. Can run on 120 volts for single pump applications (configuration required) Smoothly integrates with bwa, ControlMySpa, bba. The BP100 works with all of Balboa's TP and SpaTouch Panels.

NOTE: This control should be installed by a technician experienced with Balboa programming and setup.

Features:

• 15.0" Long Detached Remote Heater, Topside 4.35 x 1.58" drops into a cutout 3-3/4 x 1"
• BP capable features, TP200T topside with filler plate, 85 inch long cable. Plate is 8.5 x 3.5"
• Balboa ControlMySpa wifi compatible (Sold Separately)
  
• Works with the newest TP/SpaTouch Panels (sold separately)

*The Balboa BP100 is factory configured for 240 volt applications, pump(s) and ozonator must be 240 volts.

Can be configured for 120 volt but pumps and ozonator must all be 120 volts.

*Pump 1, Circ Pump and Ozone must be the same voltage

*If installing a 24 hour circulation pump, it must have no less than a 23 GPM flow. Laing, Grundfos or Waterway Tiny Might pumps do not perform at this rate and cannot be used.

Balboa BP100 Control System with Remote Heater and TP200T Panel.

Does not include pump or blower power cords. Cords available here:

Pump Power Cord

Single Speed Cord for Pump or Blower

A replacement for older Balboa controls including VS100, VS300, VS500Z, VS501Z, VS501SZ, VS503SZ, VS504SZ, and BP501G1

Manual

FEATURES:

• Lowest cost entry level BP System
• Works with all of Balboa’s TP Panels
• Works with all of Balboa’s SpaTouch™ Panels
• Built with premium materials, the remote spa heater is engineered for easy installation