Spa Heater Element - Hot Tub Heater Element - Spa Heating Element

Spa Heater Element - Hot Tub Heater Element - Spa Heating Element - Hot Tub Heating Element - Spa Heater Coil.

Premium Element with Incoloy 800 Sheath material. 9.9" overall length, perfect replacement for M7 heaters, and most flo-thru spa heaters with 2-1/4" OD housings for 1-1/2" or 2" piping systems. In 4.0kW, 5.0kW, 5.5kW. Also available in 2.0 & 2.5kW upon request.

Includes installation instructions. Fits Flo-Thru Heaters by RMF, Therm Products, Balboa, Gecko, Hydroquip, Waterway, Applied Computer Controls, United Spa Controls, Brett Aqualine, Pinnacle, Spa Builders, Marquis, Master Spas, Freeflow, Artesian, Cal Spa, Tiger River, and many other branded Flow-Through Spa Heaters. For high flow heaters with minimum of 20 GPM flow, and 1-1/2" or 2" piping.

Includes 2 flange gaskets for the ends of your Flo-Thru heater housing, in durable Buna Nitrile rubber. Offset terminals for 1/2" holes with 1-1/4" terminal spacing.

Includes hardware, o-rings, nut, washers. Our Tech Support is always standing by to help you with assembly & testing.

Caution on startup procedure, do NOT put power to the heater until after the pump has run a good 20

minutes or more so all air is out of the system. In other words, DO NOT TURN UP THE TEMPERATURE

until you run the pump 20 minutes minimum, AND INSURE ALL AIR IS OUT OF THE PIPING. Failure to

follow this important procedure runs the risk of dry-firing the element, and BURNING IT UP.

	Viton Seal Kit Spa Pump Shaft Seal 1213004 PPUFSEALVITON PPSFSEALV2, seals for Ultra Jet® pumps for DJAY, PUUL, PUUM, PUUP, PUBF, Theraflo $25.95